The introduction of Gloway series memory attached is as follows:

Gloway DDR5 7200MHz memory kit is built with Hynix A-Die particles, and its operating timing is as low as CL34 at frequencies up to 7200MHz.

The Gloway series uses thickened 10μm gold fingers to prolong the service life of the memory. Through advanced materials and design, the durability of the gold fingers is greatly enhanced.

The Gloway DDR5 memory released this time uses a 10-layer PCB board with stronger electrical performance on the basis of selecting specially selected Hynix A-Die overclocking particles. According to the official, the 10-layer PCB board is a mature basic configuration for overclocking. It uses an advanced stacking design to stack circuit wiring layers to provide players with unprecedented performance improvements.

In addition, this series of memory adopts a new heat dissipation design, and a copper vapor chamber is added inside the heat sink with a thickness of 2.0mm. The copper sheet is closely attached to the heat-conducting silicone grease, and the heat-conducting performance is combined to provide stronger heat dissipation support when the memory is running at high frequency and manual overclocking. At the same time, both sides of the product use graphics card-level high-performance silicone grease cooling pads, which are close to the heat sink, PCB and particles, and can conduct heat effectively even if they are deeply involved in the thermal battlefield.

The post Gloway DDR5-7200 memory is listed, 32GB priced at 1499 CNY appeared first on TechGoing.

The design of the Gloway series is inspired by the Amicc Army, one of the six armies of the Tang Dynasty.

The official introduction of the Gloway Amicc series memory is as follows:

Gloway Amicc series memory uses high thermal conductivity silicon grease heat dissipation adhesive on both sides, which is close to the heat sink, PCB and particles; thickened 10μm gold fingers are used to extend the service life of the memory, through advanced materials and Design, the durability of the gold finger is greatly enhanced, without worrying about the oxidation and scratching of the gold finger; the light guide strip is combined with the lamp bead support of Amicc technology, supporting 16.8 million RGB colors; the power supply is enhanced, and it does not lock The design of PMIC voltage has more powerful performance after overclocking; Hynix A-Die particles are selected, and the original particles use advanced manufacturing technology and high-quality materials.

Guangwei Amicc DDR5 6800MHz will be launched in the near future, and 6400/7200/7600/8000MHz specifications will also be launched one after another.

The post Gloway releases Amicc series DDR5 memory, 10-layer PCB appeared first on TechGoing.

According to the introduction, the product continues the design of the Tianze series, which has passed the basic performance test and will be officially launched in the near future.

In terms of overclocking performance, the Lightway DDR5-6000 48GB (24GB*2) memory is overclocked to 7000MHz with a read speed of 101991MB/S and a write speed of 90507MB/S with a latency of 75.6ns and a timing of 46-50-50-84. The memory is overclocked to 7200MHz with a read speed of 100390MB/S and a write speed of 92169MB/S. The memory is overclocked to 7200MHz with read speeds of 100390MB/S, write speeds of 92169MB/S, a latency of 75.4ns, and timings of 46-50-50-84.

The post Gloway will soon launch a single 24GB DDR5 high-end gaming overclocking bar appeared first on TechGoing.